DISCLAIMER, these are not drop in and require some tuning/adjustment.To Order email me at firstname.lastname@example.orgFrames that my Autotrigger Fits:
Benchmark, Belsales, Dye, KAPP, Freeflow, ANS, and more
DYE, 32 degreesFrames that my Autotrigger Does NOT fit:
WGP & Powerlyte both require modding
Eclipse, Kapp Reflex, CCM FramesAutotrigger $50Modded Stock WGP Trigger Plates $20 each
I have a small amount of them, i premodded them to make installation MUCH easier
Trigger Plate Modification:
based on excess metal in plate and plate hardness$10 to Mod a stock Slider trigger plate
$20 to mod a ANS trigger plate
$50 AKA trigger plate
turnaround is about 3 daysDrill & Tap Pump Rod for Lever Screw $10
turnaround is 1 dayFAQWhat pump kit mods are needed for an autotrigger?
A Pump rod with 4-40 tapped hole drilled into it.What MODs do DYE Pivot frames need for an autotrigger?
NONE!What MODs Slider frame need for an autotrigger?
just make sure the surface is flat like in the pic...and it clears the Safety hole and you'll be OKAutotrigger Instructions click me
I use Titanium Putty from Devcon, it does wear off a little but i have had the same slider with Ti Putty for 2 years and haven't had to replace the putty yet, also it slight wears the cam polishing it like how 600 grit paper would....i have been using a cam 10 years old (using the putty plate for 2 years) and its still ok
modding your own trigger isn't that hard The Autotrigger Strikes Back!!!
thread has information, and i would much prefer you
to do it.HOW TO ORDER!!!
1) Figure out what frame you have (45 slider, Dye/32 degrees Pivot, Stock Sniper2 pivot(non 45 frames) ONLY!!!!)
2) Decide if you need your pump rod modded
3) email me your order to email@example.com
4) if needed Send necessary parts for Modding
DISCLAIMER, these are not drop in and require some tuning/adjustment.To Order email me at firstname.lastname@example.org
you can install them on autocockers, Space Time Paradox Safe