|
Koa
|
 |
« on: February 04, 2010, 01:55:35 AM » |
|
Rough Finished Parts
Overly Heavy Springs
Soft Metal
Pseudo knock off CCM frame, similar design, but shitty trigger(no roller), and doesn't fit CCM Autotriggers
Non Mirror Polished Aluminum on Aluminum parts
Smooth Lower Tube
Strange Valve Design
Strange Cup Seal Design
Poor Hammer Design
Poor Pull Pin Workmanship
out of the box this gun SUCKS!
Sucking of note, the trigger has a roughly made rounded set screw, which pushes up against the sear. A Loose Fitting Valve Stem(has oring slot, no oring)
Some Good
nice anno
light body
nice milling
smooth internal tube(SHOCKED!)
with my work, this gun will be good, better than most, because the body is decently smooth, smoother than WGP bodies
what this gun needs done?
internal work, finishing of the parts
re-springing and tuning
new trigger
softer cup seal, possible easy swap
better pull pin
polished stainless pump rods
polished stainless pump guide or sleeved with smooth material
lighter pump return spring
an autotrigger option(either fabricate or drill out for CCM)
To Buy or Not To Buy?
if there was a polished anno option i would go for it, but for 250 its a good buy if you want a halfblocked gun.
if your looking for a CCM contender save up for a used S5.
if you looking for a normal idiot baller who thinks what others think is important then buy it and enjoy your crappy gun while saying its just as smooth as a CCM when its not.
if you want a gun to work on to perform, it would be a good buy, it takes 100 more to get it up to my standards of what a pump gun should be.
|
